installation guide WIN8.1 system IWORK10 (คาดว่าวิธีนี้ใช้กับรุ่นอื่นได้ด้วยครับ)

เอามาจากเวป

http://bbs.51cube.com/thread-89199-1-1.html

Hello everyone, I am a team captain biscuit hands, this time to bring the installation guide WIN8.1 system IWORK10 the 
rear of the machine get our hands found No system, or a problem, need to re-install the system, you can refer to 
this post, the time, I put the text of the comb is good, and so empty in the figure, 
the first things you need to prepare: 1, OTG line , 2, WIN8.1 a system ( 

http://pan.baidu.com/s/1eQBqDNG ) 
3, U disk a greater than 4G, speed priority, so that the system can effectively ensure the installation of speed 
4, IWORK10 a (must be) it is

better now to start the installation tutorial: 
1, first unzip the downloaded WIN8.1 system ( be sure to unzip all files to the root directory, which enables the system to recognize the ) 
and copy ready before on the U disk, TF card can also be currently testing with an external card reader 

2, connected with OTG cable tray and tablet computer 

3, switched on and press the ESC key several times to enter BIOS, then, select your BOOT U disk as the first boot mode 




(currently tests can use F7 to boot mode selection, this step can be ignored, if not carried out in accordance with this step in) 

4, F4 to save and restart, so IWORK10 can automatically scan your U disk and loading, during loading, CUBELOGO following will be a circle in the rotation, after a few seconds, flash DOS window interface to 

5, in a DOS window interface, enter " CD \ "retreated to the root directory, and then enter" : D into the D disk drive status, then enter "df.bat "Enter, and so on back to the D drive is blinking, enter" da.bat after "Enter, after the implementation, progress bar, etc. 100% complete ,

enter exit to exit and restart automatically IWORK10,

so far, your system is installed, theabove is the installation of the system, after installation, remember to desktop mode testing WIFI and Bluetooth, to see whether work is currently no large I tested The problem, I will further driver installation instructions in the second floor.

As shown below:






Fourth system will automatically restart, and then enter the X: \ Windows \ system32> Wpeinit    
                           X:. \ Windows \ system32> interface 


following figure show: 




five: start the following steps to install the system, install the system simply by entering the following at the command window a few red font commands: as shown Note (if your device before the system has been installed, then please enter "D:", if your machine is not brush off the system, then enter "C:".) The following operational guidelines are not brush off the system, so we have to enter "C:" to operate.


1. At the command window, type "C:" , as shown below: 2. In the red box enter the following diagram: CF.BAT . In this case the command window will print out some information until after the messages stop print continue to enter the following command ** Please do not move 










as shown below: 



3 until the message when printing to the following screen, in the following chart red mark and then enter " CA.BAT ",as shown below: 








4. In the following screen enter: " CA.BAT "command, as shown below: In this case the command window displays the progress of the percentage of the installation of the system, wait for the progress shown as 100 percent, enter the following command in the following screen enter " Exit "command, as shown below as follows: 6 (** This is the exit after the command, enter the command device automatically reboot to win8 system interface **) 7. The installation is complete.